Malmet WDS Series, Руководство по эксплуатации, техническому обслуживанию и установке

Страница: 32 / 54

WDS
Operation, Maintenance and Installation Manual
Issue 11 Page 31 14/02/2019
Purging must only be undertaken by Malmet service personal of Malmet trained facility maintenance personal.
5.7 Purge Reset (Maintenance)
1.
Turn power OFF at control LCD display
2. Turn power ON at control LCD display
3. Hold down both SCROLL and SELECT buttons, when MENU is displayed, release buttons
4. SCROLL to SERVICE menu and press SELECT
5. SCROLL to RESET menu and press SELECT ‘CONFIRM’ should then display
6. Press SELECT again to start Purge Reset cycle
When purge reset is completed the display will resume normal operation
5.8 Purge Detergent Line (Maintenance)
1.
Turn power OFF at control LCD display
2. Turn power ON at control LCD display
3. Hold down both SCROLL and SELECT buttons, when MENU is displayed, release buttons
4. SCROLL to TEST menu and press SELECT RELAY
5. SCROLL to DETERG menu and press SELECT START press SELECT START/RUNNING
The detergent pump will run for 5 seconds, if detergent line completely purged display shows PASS; then DETERG
If display shows FAIL then DETERG repeat steps SELECT START; press SELECT
To EXIT
1.
SCROLL to EXIT press SELECT
2. SCROLL to EXIT press SELECT
3. SCROLL to EXIT press SELECT
LCD display goes blank