TJ-JA/JZ-140516
Towel Warmer Sofie
Model: BK-109B, BK-109A-10
94 127 14, 99 940 60
inSTruCTiOn Manual
SafETY prECauTiOnS
•
This towel warmer is intended for the use in bathrooms or
laundry areas to dry and heat bath towels and clothes.
•
Do not use in areas where gasoline, paint or flammable
liquids are kept.
•
Do not use outdoors.
•
The heater only operates in upright position.
•
always disconnect heater when cleaning or not in use. To
disconnect heater, remove plug from outlet.
•
Do not operate the towel warmer if it is damaged.
•
arrange cord away from traffic area and where it will not
be tripped over.
•
Do not store until the heater has cooled down.
•
use this heater only as described in this manual. any other
use not recommended by the manufacturer may cause
fire, electric shock, or injury to persons.
•
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabili-
ties, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
•
Children should be supervised to ensure that they do not
play with the appliance.
•
if the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified person
in order to avoid a hazard.
(See picture A)
EN
DESCripTiOn Of parTS
OpEraTing inSTruCTiOnS
1. Make sure to complete the installation properly.
2. press the switch to (0) position.
3. plug the power cord into an electrical outlet.
4. press the switch to (1) position, the power indicator illumi-
nates and the heater will start.
Read the instructions carefully before operating and keep the manual for future reference.
inSTallaTiOn inSTruCTiOnS
The towel warmer must not be installed in close vicin-
ity to water. A distance of at least 0.6 metres between
towel warmer and screened off shower or wash-basin
is required. If the shower is not screened off the safety
distance is 1.2 metres.
1. Mark screw holes on the wall with a pencil.
2. Drill holes in the wall.
3. insert screw anchors into the holes.
4. rivet the base on nut of the product with setscrews
(see picture B).
5. install foot base with screw (see picture C).
Malmbergs Elektriska aB, pO Box 144, SE-692 23 kumla, SWEDEn
phone: +46 (0)19 58 77 00 fax: +46 (0)19 57 11 77 [email protected] www.malmbergs.com
SpECifiCaTiOnS
Art.no:
94 127 14
99 940 60
Voltage:
220-240v aC
Frequency:
50Hz
Rated power:
70W
100W
Dims WxHxD:
500x800x125 mm 500x1150x125 mm
Weight:
2.8 kgs
3.5 kgs
Material:
Stainless steel with polished surface
Protection class:
ip21
1. Towel rail
2. Support
3. On/off switch
4. power cord and plug
A
B
C