Malloca MWC-24CP, Инструкция по эксплуатации

Страница: 10 / 33

Method of installation
1. A square hole of an appropriate size shall be located at the designed position on the cabinet, and
the cooler shall be embedded into the square hole stably. The specified dimensions of the square
hole are shown in the right figure:
2. The cooler shall be fixed reliably in the cabinet. 6 fixing screws shall be installed on left and right
sides of the door frame and in the top holes of the cooler.
Precautions for operation
1. Clean the cooler.
Before operation, clean the cooler inside, and check whether the vent pipe is clogged.
2. Keep the cooler level for 30 minutes.
After the cooler is leveled and cleaned, do not electrify it immediately. Keep the cooler stationary for
more than 30 minutes, and then electrify it to ensure the normal operation of the cooler.
3.
Close the cooler door, and insert the power line.
After the power supply is switched on, the cooler will start to work. If the cooler fails to work in a long
period of time, check whether the power socket and the electric circuit work normally. If, half an hour later,
an abrupt reduction of temperature is detected after the cooler door is opened, the cooler works normally.
4.
Generally, do not stop the cooler, to avoid influencing its normal service life. After the power line
plug is removed, wait for at least 5 minutes before inserting it again, to ensure the normal operation
of the cooler.
5. Do not switch off the power supply of the cooler when unnecessary, because the power interruption
may cause temperature rise inside the cooler, thus to shorten the storage term of wines and
degrade their drinking quality.
6. A certain space shall be maintained between wine bottles, which will facilitate the circulation of cool
air.
7. It is not allowed to flush the cooler body using water, nor to wipe the body using the gasoline or
other organic solvents.
8. If the power cord is damaged, it must be replaced by the professional of the manufacturer, its repair
department or any similar department to avoid any danger.
9. All power sockets must be reliably earthed.
10. The system shall be set up during the initial operation of the product for better protection of this
product.
9