8
locked.
The electronic control remains locked until it unlocked by the user, even if it has been switched off
and back on mean- while. Not even touch control resetting (after a voltage drop) will interrupt the
button lock.
Cancelling the button lock:
After switching the touch control on, the child safety feature can be disabled. Press the left cooking
zone selection button and the MINUS button (2) for 3 seconds, followed by just the MINUS button
(2). If all operations are carried out in the right order within 10 seconds, the button lock will be
cancelled and the touch control switched off. Otherwise, the sequence will be considered incomplete
and the touch control will re- main locked and will switch off after 20 seconds.
Switch the touch control back on using the ON/OFF button and all displays will be indicate “0”, the
decimal points will flash and the touch control will be ready for cooking. If a cooking zone is in “hot”
mode, “0” and “H” will be alterna- tely displayed.
Control of multiple circuits
Hob with triple zone.
When a dual/ triple cooking zone is activated, the 3 circuits are switched on at the same time. The
activation / deactivation of each circuit is done with button 4 and it is indicated with an illuminated
segment.
Sound signal (buzzer)
While the control is in operation the following activities will be signaled by means of a buzzer:
o
Normal key activation with a short sound signal.
o
3 short acoustic signals (beeps) for turning off the touch control.
Maintenance
Any remains of aluminium foil, food, fat, sugar or food with high sugar content must be
immediately removed from the hob surface to prevent potential damage to the hob surface.
Subsequently clean the surface with some towel and appropriate product, rinse with water and dry
by means of a clean cloth. Under no circumstance should sponges or abrasive cloths be used; also
avoid using aggressive chemical detergents such as oven sprays and spot removers.
Installer’s Instructions
Installation
These Instructions are for the qualified technician, as a guide to installation, adjustment and
maintenance, according to the laws and standards in force. These operations must always be carried
out when the appliance has been disconnected from the electric system.
Positioning (Fig. 3,4)
1.
Front view
2.
Front side
The fixture is especially designed for fitting into a work-top as shown in the corresponding figure.
Place the supplied sealing agent along the hob perimeter.
Do not install the hob over an oven; in case you do, make sure of the following:
-
the oven is equipped with an appropriate cooling system
-
there is no warm-air leakage from the oven towards the hob
-
Suitable air-inlets are provided as shown in the figure.
Electrical connection
Prior to carrying out the electrical connection, please ensure that:
The plant characteristics are such as to follow what is indicated on the matrix plate placed at
the bottom of the working area;
That the plant is fitted with an efficient earth connection, following the standards and law
provisions in force.
The earth connection is compulsory in terms of the law.
Should there be no cable and/or plug on the equipment, use suitable absorption material for the
working temperature as well, as indicated on the matrix plate. Under no circumstance must the cable
Содержание MR 593
