WF306
GENERAL INSTRUCTIONS FOR WATERFALL USE
1. Unpack the product, wipe off dust with a damp cloth. Take out all
accessories: River rocks, pump, adapter, and waterfall parts
(See diagram).
2. Familiarize yourself with the pump. Turn valve on pump counter
clockwise placing the handle in a horizontal position for
maximum water flow. Turn the valve on the pump in a vertical
position for minimum water flow.
CAUTION: This pump has been evaluated for use with water only.
NOTE: It is recommended the pump be set at its highest flow
during assembly and later adjusted to a lower setting if desired.
Be sure to unplug pump before adjusting flow setting.
WARNING
: RISK OF ELECTRICAL SHOCK
• Do not connect to any voltage other than that shown on the pump.
• This pump is supplied with a grounding conductor and grounding-
type attachment plug. To reduce the risk of electric shock, be
certain that it is connected only to a properly grounded,
grounding-type receptacle.
• The national electric code requires that a ground fault circuit
interrupter (GFCI) be used in the branch circuit supplying
waterfall pumps and other pond equipment. See your
electrical supplies dealer for this device.
• If the supply cable is damaged it can not be replaced and
the pump unit should be discarded.
WARNING
: RISK OF FIRE
• Do not use with water above 30˚C.
• Do not pump flammable liquids.
WATERFALL ASSEMBLY
1. Place base of waterfall on a level surface.
2. Take copper top tubing and screw in intermediate copper tubes.
3. Take copper tube assembly and attach to waterfall cover securing with nuts and washers ~ provided.
4. Attach the clear plastic tube to pump and other end of tube to copper tubing protruding below bottom of waterfall cover.
5. Once assembled, place the waterfall cover in base of waterfall.
6. Place pump in the base of waterfall ensuring that the wires go out the notches located on the back of the waterfall
base and cover.
7. Locate Panel A slate piece.
8. Using the brackets and screws attach Panel A to the top of the copper tubing.
9. Make sure bevel is toward the front.
10.Attach middle Panel B to the back of top slate piece using screws and nuts, tighten.
11. Attach Panel C to the back of middle slate using the screws and nuts, tighten.
12.Connect the pump and connect the power cord to the AC adapter DO NOT plug into
outlet at this time.
Once assembled, place the waterfall lid in base of waterfall.
WARNING
:
Place hook or nail (not included) or choose an attachment mechanism appropriate for your wall in wall and secure
fountain by placing hook or nail in chain. Please ensure that product is assembled according to the directions
provided in this information packet. Doing these things will increase safety measures and avoid tipping of the waterfall.
NOTE: Do not let pump run when NOT submerged in water. Doing so may damage the pump. Always submerge
the pump in water first, and then plug in the unit.
14. Fill base with distilled water to approximately 1/2" above pump. Use distilled water only. Tap water will create mineral
deposits that will result in the corruption of the Waterfall and pump.
15. Plug adapter into 120V household outlet. Put stones on the lid. (The waterfall is controlled by the switch on the power
cord.) If pump doesn't operate, rotate in-line switch once to turn to "off" and once to turn to "on."
WARNING
: This is not a toy. To avoid danger of choking keep small river rocks away from Children and Pets.
NOTE: Ensure that the electrical cord loop is below the electrical outlet.” This will prevent water from running
down the cord into the electrical outlet.
CAP
(6) PCS
(6) SCREWS
RESERVOIR
SLATE
PANEL C
PANEL B
PANEL A
LID
NUT
(2) PCS
