Malibu Boats Wakesetter 20VTX 2018 Скачать руководство пользователя страница 74

Страница: 74 / 200

Malibu Owners Manual • 2018 • Dashes and Video Screens • Page 3-5

1. With the engine running and in neutral, turn the speed control on by

touching the SPEED CONTROL button. The button will turn green and
ON will be displayed. SPEED READY is displayed above the throttle bar.
Touching the speed control button yet again turns the speed control off.

2. Choose a desired set speed by touching the SPEED UP/DOWN buttons.
3. Advance the throttle position until the engine takes control and SPEED

ENGAGED is displayed. A throttle target window appears on the throttle

bar until the engine disengages cruise.

4. Keep the orange throttle marker inside the throttle target window.

5. Throttle position adjustment is needed if the orange throttle marker moves outside the target window. If to the left, MORE

THROTTLE is displayed until the marker is back inside the window. If to the right, OVER SPEED MODE is displayed until the
marker is back inside the window. The driver controls the speed of the boat until the marker is back inside the window.

6. Touch SPEED UP/DOWN buttons to adjust the desired set speed in 0.1 mph increments, after the engine has control. Touch and

hold the button to quicken the rate of change.

7. Returning the throttle position to neutral will disengage the speed control. Speed control will still be on, but disengaged.
8. Turn the speed control off by touching the SPEED CONTROL button, and disengage the engine by returning the throttle position

to neutral. SPEED OFF appears above the throttle bar.

Speed Input:

Press the SPEED INPUT button to access the screen below.

Select the desired speed input source by pressing either PADDLE WHEEL or

ZERO OFF-GPS. Changes will not take place until the throttle is put into the

idle position.

SURF GATE CONTROL

Easily create a surf wake, and switch from side-to-side without adjusting ballast.

When speed exceeds 13.6 mph, the Surf Gates will automatically move to the center position until the speed returns
to less than 13.6 mph.

Surf Gate Operation

: The Surf Gates must be calibrated before use to work

properly. Follow the procedure in the Settings menu. Adjust the desired
position of the Surf Gate using the control buttons.

Surf LEFT or RIGHT and SWITCH the wake from side-to-side with the

touch of a Surf Gate control button. The selected position changes to white and

a progress meter appears until the position is achieved

while the boat speed is 7.0 to 13.6 mph, and no alarms are active.

The selected position will be in ready mode when the boat speed is out-of-range or an alarm is active. Both Surf Gates retract in

the center position. Normal Surf Gate system operation will resume after the alarm condition(s) is/are resolved and the notifications
are acknowledged. Refer to the following list of Surf Gate alarms.

To alert the driver and rider of a Surf Gate position switch (from left to right or right to left), the tower lights will flash and

audible beeps will sound. These alerts can be disabled in the

SETTINGS

menu.

Possible Surf Gate Alarms:

Under certain operating conditions, Surf Gate alarm notices appear:

MAX CURRENT DRAW EXTENDING LEFT:

There is an error with the left surf actuator.

MAX CURRENT DRAW RETRACTING LEFT:

There is an error with the left surf actuator.

MAX CURRENT DRAW EXTENDING RIGHT:

There is an error with the right surf actuator.