ASSEMBLING & INSTALLATION OF THE LIGHT,
OPERATION INSTRUCTIONS
Please pay attention to place your light in a non-shaded place with
sufficient sunshine provided for its operation.
Assembling & installation of the light:
1.
All light parts (light dome, column parts, stand/pin) are threaded, they
can be assembled by turning the threaded parts correctly.
2.
The height of the light depends on how many column parts you fix with
each other. 3 different heights can be set up.
3.
Before fixing the light dome on the top
column part, please turn on the light by
pressing the main ON/OFF button. The black
button is located on the bottom of the dome,
in the middle.
Please do not remove the
plastic cover from the button! The button
can be pressed by pressing the protective
cover at the button’s location!
The light
turns on after you press the main ON/OFF
button (in daytime the light sensor switches
off the light after a few seconds, and will turn it on again at dusk.
The solar panel starts charging the battery immediately considering
sufficient light is provided).
4.
If you would like to fix your light in soil, attach the pin to the lowest
column part, and position the light at the chosen location.
5.
If you would like to fix your light on a hard surface, please follow the
instructions below:
a) Please care that the horizontal surface you are about to fix your light on
should be levelled correctly. It is recommended to position the light on
its final place, then mark the 3 locations of the holes.
b) After marking the locations of the holes, remove the light, and drill
the holes.
c) Push the anchors inside the holes.
d) Place the light on its final position, and drive in the screws with a
screwdriver.
5
Содержание HELIODOR 7
Страница 2: ...2 ...
