Malaguti Blog 126, Руководство по обслуживанию

Страница: 24 / 79

24 03/09
125 - 160 cc
Blog Blog Blog Blog Blog
F. 32
F. 33
F. 34
P
A
F. 31
W
S
V
3
B
• Replace the previously removed 30 A general protection fuse
in its place.
• Check that the battery and cables are properly positioned;
then remount the battery fastening cover.
• Remount the central panel under the seat.
NEVER invert the cable connections.
Do not use the battery without the battery
inserted and connected to wires of the main
harness. This could cause breakdowns and
short circuits in the electrical system and
components.
It is advisable to use gloves and protective
eyewear, when the battery must be removed
from its housing; for example, when it needs to
be recharged.
Make sure that the tilt sensor (B) is perfectly
horizontal.
Danger of explosion! Do not use open flames
(lighters, matchsticks, etc.).
The battery contains highly toxic sulphuric acid.
Avoid contact with the eyes, skin, and clothes.
Keep the battery out of reach from children.
If for charging/maintenance of the battery the
special electrical outlet connection is used,
open the battery case to permit proper
ventilation.
CHARGE BATTERY
• To carry out this operation, it is advisable to remove the
battery from its housing, unless the special electrical outlet is
used.
• Disconnect cables.
• It is a good rule to recharge using amperage that is equal to
1/10 of the power of the battery.
• Remount the battery, paying attention to connect the positive
cable (red/blue) to the + pole and the negative cable to the -
pole.
• Properly tighten the battery clamps.
• It is important that the battery always remains fully charged;
therefore, during the winter months or when the vehicle re-
mains unused, it should be recharged at least once a month.
BATTERY (12V - 9Ah)
The battery housing is located in the central tunnel.
BATTERY ASSEMBLY (PRE-DELIVERY OPERATION)
• Take the battery that has been previously charged
• Apply the adhesive strip (A) supplied in the kit, by removing
the protective film located on the end of the adhesive area,
shown by the arrows (P).
• Remove the 30 A general protection fuse.
• Unscrew the three screws (V3) and remove the central panel
under the seat (S).
• Remove the battery fastening cover by removing the 3
screws (W).
• Insert the battery, ensuring it fits in its housing.
• Connect the battery to the cables
- positive pole (+) RED/BLUE wires
- negative pole (-) BLACK wires
• Properly tighten the battery clamps.
• Properly position the battery clamps.