Maktec MT690, Инструкция по эксплуатации

Страница: 6 / 12

6
CAUTION:
•
Always check the direction of rotation before
operation.
•
Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
•
When not operating the tool, always set the
reversing switch lever to the neutral position.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
004521
Use only bits that has inserting portion shown in the
figure.
For tool with shallow bit hole
A=12mm
B=9mm
Use only these type of bit. Follow the
procedure (1).
(Note) Bit-piece is not necessary.
006348
For tool with deep bit hole
To install these types of bits, follow
the procedure (1).
To install these types of bits, follow
the procedure (2).
(Note) Bit-piece is necessary for
installing the bit.
A=17mm
B=14mm
A=12mm
B=9mm
011405
Procedure (1)
1
2
012996
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
Procedure (2)
In addition to the procedure(1) above, insert the bit-piece
into the sleeve with its pointed end facing in.
1
2
3
012997
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
NOTE:
•
If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
•
After inserting the bit, make sure that it is firmly
secured. If it comes out, do not use it.
Hook (Optional accessory)
1
2
3
012998
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
1. Groove
2. Hook
3. Screw
1. Bit
2. Bit-piece
3. Sleeve
1. Bit
2. Sleeve