13
• Any other condition that could impair the safe operation of this equipment.
6.1 Table and Support Base
• Cleaning the LD.300 sander is relatively easy with a vacuum cleaner to remove excess wood
chips and sawdust, and dust with a dry cloth. If there is any resin, use a resin remover and a clean
cloth to remove it.
• Protect the unpainted cast iron surfaces on the table by wiping the table clean after each
use, which ensures moisture from wood dust does not remain in contact with untreated metal
surfaces.
• Make regular applications of anti-rust or a quality metal protector.
• Always remove dust accumulated on moving parts, such as axles and the motor. Lack of cleanliness
and excess of dirt can block some moving part, preventing the sandpaper from moving freely.
6.2 Lubrication
Since all bearings are shielded and permanently lubricated, just leave them in this way until they
need to be replaced. Do not lubricate them. For the other items on this machine, an occasional
application of electric machine oil is all that is needed. Before applying the lubricant, clean the
sawdust. Its objective is to achieve adequate lubrication. Too much lubrication will attract dirt and
sawdust. Various parts of your machine can lose their freedom of movement with excess dirt caused
by excessive lubrication.
6.3 Maintenance Schedule
Daily:
• Vacuum all the dust from above and around the machine.
• Clean the table and all unpainted cast iron with a metal protector.
Monthly:
• Check the sander for damage or wear.
• Clean the accumulation of dust inside and outside the engine.
6.4 Replacement of Garbage
Install the sandpaper as follows: Remove the support table from the front of the disc. Peel off the
adhesive film from the back of the 12 ’’ sandpaper and carefully apply it to the disc.
