MAKSIWA CBC.T, Инструкция по эксплуатации

Страница: 17 / 80

17
5 Operation
5.3 Edge Feeding
Edge Positioning
1. Put the edge between the two stainless steel
guides B.
2. Keep the vertical position of the edge with the
hold down knobs A which is coupled with a
screw.
3. Set the knob and the screw 45° slot to achieve
the vertical setting of the coil. It is advisable
to leave a 0.5 mm vertical play to the coil for
smooth sliding.
Guillotine Knife
Guillotine knife is used to cut the edge from the
coil. The cutting amount has been set in the factory.
How to adjust the cutting amount?
1. Free the two screws G.
2. Move the electric switch H toward to the
entrance of the work-piece to reduce the extra
length.
3. Move backward to increase the extra length.
4. Fix two screws G.
Place Edge
1. Push knob D to the right side to open roller C.
2. Put the end of edge manually passing between
the plastic roller C and rubber roller B until
reach pressure roller.
3. Free the nut I and adjust knob F to touch the
edge and move up about 0.5mm higher than
the edge. Lock nut I.
4. Pull the edge back to the guillotine knife point
E for standby position.