9
Misprints and printing errors reserved
If the float is floating, the system is on stand-by. If the
float is in the lowest position, the process will commence
(drum starts rotating and the rinse pump will rinse the
cloth). This will last for 14 seconds.
If
the float remains in the lowest position (and the pond
pump is on) there will be too little water supply from the
pond. The drum will rinse for 30 seconds (standard value)
and then switch to dry-running mode.
This is to protect
your pond pump.
Once the float goes
back to normal
position (it will float
again because
sufficient water flew
into the filter) the
pump will activate
after 5 minutes
(standard value).
7.2.6 Control electronics
The control electronics has protection class IP54.
Electrical installations must always comply with the
national and international requirements/guidelines.
Only open the casing of the electronics to
connect the float and magnet contact or to
set the parameters. When connecting the
float and magnet contact, disconnect the
device from the power supply before
connecting it! Changing the parameters is done at own risk
in case the power supply is connected. Take care of
electrical hazard when opening.
The control cabinet must be connected
to an approved, earthed socket. The
electronics must be installed vertically.
The electronics may not be assembled
unprotected during rain. Per connected
side, a maximum of 660 W of auxiliary
equipment may be connected.
Functions of the green button:
Press 1 time:
Filter will start to rinse.
Quickly press 2 times:
Filter and duct will rinse*
Quickly press 4 times:
Filter into emergency mode
Periodic rinsing.
If float is defective.
Press for 3 seconds:
Rinse counter reset.
Press for 8 seconds:
Text message module
sends (test) alarm.
While pressing:
Total number of rinses
visible on screen.
Connection 1-2:
Float switch
Connection 3-4:
Lid of magnet contact. This is a
protection for opening the lid. If the lid is opened, the
drum filter will not rinse.
Display on white:
Filter is operational
Display red:
Lid is open and drum filter will not rinse!
Pond pump will keep running. This is only when the
Float is
in ‘
rinse
’
position, pond pump is on.
Drum is rotating and rinse pump rinses the
cloth. If the float remains in this position for
30 seconds, the electronics will switch to
DRY-RUNNING MODE.
Motor
Pond pump
Rinse pump