8
Misprints and printing errors reserved
You connect the exit of the Rinse pump with a hose (or
even better, PVC) to the
¾’’
cable that is assembled to the
pipe with the nozzles.
Ensure proper adhesion bonding! The pipe is under
pressure during rinsing! Use high pressure PVC. The plug
of the rinse pump must be connected to the electronics in
the FLUSHING PUMP plug.
7.2.4. Connecting motor drum filter
The plug of the motor of the drum filter must be connected
with the control electronics. Use the plug connection
'MOTOR DRUM FILTER'.
7.2.5 Coil frequency
Make sure that the coil frequency is not too high. If the
drum is installed in an existing system, the coil frequency
will be high over the first days/weeks, because the pond is
being
‘
cleaned
’.
In case of warm weather, the coil
frequency will be higher (more feed and more algae
growth) than in case of colder weather.
Other causes of a (too) high coil frequency are:
•
a pond pump that is too large
•
too little water is supplied, due to a low pond
water level or incorrect supply system from the
pond, e.g. too long pipes, too few pipes or pipes
with an insufficient diameter
•
Float is set too high
•
Clogged mesh, due to e.g. bacteria
•
Too little pressure in rinse pump
•
Too little flow from rinse pump
Float is
in ‘normal’
position, pond pump is
on.
