14 ENGLISH
Using the straight guide for circular
work
For circular work, assemble the straight guide as shown
in the figures. The minimum and maximum radius of
circles to be cut (distance between the center of circle
and the center of bit) are as follows:
•
Minimum: 70 mm (2-3/4")
•
Maximum: 221 mm (8-11/16")
For cutting circles between 70 mm (2-3/4") and 121
mm (4-3/4") in radius.
1
►
1.
Center hole
For cutting circles between 121 mm (4-3/4") and 221
mm (8-11/16") in radius.
1
►
1.
Center hole
NOTE:
Circles between 172 mm (6-3/4") and 186 mm
(7-5/16") in radius cannot be cut using this guide.
Align the center hole in the straight guide with the
center of the circle to be cut. Drive a nail less than 6
mm (1/4") in diameter into the center hole to secure
the straight guide. Pivot the tool around the nail in the
clockwise direction.
2
1
►
1.
Nail
2.
Center hole
Using the templet guide
Optional accessory
The templet guide allows for repetitive cut with templet
patterns by using a templet.
1.
Loosen the screws on the base plate, and then
remove the base plate from the trimmer base.
2.
Place the templet guide on the base, and then
attach the base plate by tightening the screws.
1
2
►
1.
Base plate
2.
Templet guide
3.
Place the tool on the templet and move the tool
with the templet guide sliding along the side of the
templet.
Содержание XTR01
Страница 39: ...39 ...