Makita XTR01, Инструкция по эксплуатации

Страница: 13 / 40

13 ENGLISH
1
3
2
► 1. Trimmer bit 2. Workpiece 3. Straight guide
NOTICE:
Since excessive cutting may cause
overload of the motor or difficulty in controlling
the tool, the depth of cut should not be more than
3 mm (1/8") at a pass when cutting grooves. When
you wish to cut grooves more than 3 mm (1/8") deep,
make several passes with progressively deeper bit
settings.
Using the straight guide
Optional accessory
1. Assemble the straight guide with the bolt and the
wing nut.
2
1
► 1. Bolt 2. Wing nut
2. Attach the straight guide to the trimmer base with
the clamp screw.
1
►
1.
Clamp screw
3. Loosen the wing nut on the straight guide and
adjust the distance between the bit and the straight
guide. At the desired distance, tighten the wing nut.
1
►
1.
Wing nut
4. Move the tool with the straight guide flush with the
side of the workpiece.
If the distance (A) between the side of the workpiece
and the cutting position is too wide for the straight
guide, or if the side of the workpiece is not straight, the
straight guide cannot be used.
In this case, firmly clamp a straight board to the work -
piece and use it as a guide against the trimmer base.
Feed the tool in the direction of the arrow.
A