Makita XT612M, Инструкция по эксплуатации

Страница: 85 / 148

9
1
0-45
0-50
015116
Use the 45° stopper when you do precise 45° angle
cutting. Turn the stopper counterclockwise fully for bevel
cut (0° - 45°) and turn it clockwise for 0° - 50° bevel cuts.
Sighting
1
2
3
015106
For straight cuts, align the 0° position on the front of the
base with your cutting line. For 45° bevel cuts, align the 45°
position with it. The position of the top guide is adjustable.
Lighting the lamp
CAUTION:
•
Do not look in the lamp or see the source of lamp
directly.
1
015154
Only to turn on the lamp, pull the switch trigger without
pressing the lock-off lever. To turn on the lamp and run
the tool, press the lock-off lever and pull the switch
trigger with pressing the lock-off lever. The lamp keeps
on lighting while the switch trigger is being pulled. The
lamp goes out 10 -15 seconds after releasing the trigger.
NOTE:
•
Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
•
Do not use gasoline, thinner or the like to clean the lens
of lamp. Using such substances will damage the lens.
Hook
CAUTION:
•
Always remove the battery when hanging the tool
with the hook.
•
Never hook the tool at high location or on
potentially unstable surface.
1
2
3
015119
The hook is convenient for hanging the tool temporarily.
To use the hook, simply turn it until it snaps into the
open position.
When not in use, always turn the hook until it snaps into
the closed position.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing saw blade
CAUTION:
•
Be sure the blade is installed with teeth pointing
up at the front of the tool.
•
Use only the Makita wrench to install or remove
the blade.
1
2
4
3
015108
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the wrench to loosen the
hex bolt clockwise. Then remove the hex bolt, outer
flange and blade.
1. Hex wrench
2. Shaft lock
3. Tighten
4. Loosen
1. Hook
2. Close
3. Open
1. Lamp
1. Cutting line
(0
ﾟ
position)
2. Cutting line
(45
ﾟ
position)
3. Screw
1. Stopper