8
ENGLISH
Speed change lever
CAUTION:
Always set the speed change lever
fully to the correct position.
If you operate the
tool with the speed change lever positioned halfway
between the "1" side and "2" side, the tool may be
damaged.
CAUTION:
Do not use the speed change lever
while the tool is running.
The tool may be damaged.
CAUTION:
If the tool is operated continuously
at low speeds for a long time, the motor will get
overloaded, resulting in tool malfunction.
To change the speed, switch off the tool first. Push the
speed change lever to display "2" for high speed or "1"
for low speed. Be sure that the speed change lever is
set to the correct position before operation. Use the
right speed for your job.
1
►
1.
Speed change lever
Displayed
number
Symbol
Speed
Applicable operation
2
High
Sanding operation
1
Low
Polishing operation
Accidental restart preventive
function
If you install the battery cartridge while pulling the
switch trigger or locking the switch trigger, the tool does
not start. To start the tool, release the switch trigger, and
then pull the switch trigger.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing side grip
CAUTION:
Tighten the caps or side grip
firmly.
Otherwise, the front cover may fall and cause
an injury.
Remove the cap and screw the side grip on the tool
securely.
The side grip can be installed on either side of the tool.
1
2
►
1.
Cap
2.
Side grip
Installing backing pad
CAUTION:
Make sure that the backing pad is
secured properly.
Loose attachment will run out of
balance and cause an excessive vibration which may
cause loss of control.
CAUTION:
Never actuate the shaft lock when
the spindle is moving. The tool may be damaged.
NOTE:
Regularly clean the accessories and spindle
to remove dust and debris. Wipe the components
clean with a cloth dampened in soapy water if
necessary.
