Makita UR100D, Инструкция по эксплуатации

Страница: 23 / 124

23 ENGLISH
Attaching the shoulder harness
►
Fig.20: 1. Hook
Attach the hooks of the shoulder harness to the tool as
shown in the figure.
CAUTION:
Be sure to attach the hooks of the
shoulder harness to the tool securely. If the hooks
are attached incompletely, they may come off and
cause injury.
Hex wrench storage
CAUTION:
Be careful not to leave the hex
wrench inserted in the tool head. It may cause
injury and/or damage to the
tool.
When not in use, store the hex wrench as shown in the
figure to keep it from
being lost.
►
Fig.21: 1. Hex wrench
OPERATION
Cutting the grass
Hold the grass trimmer at the angle of about 50° to the
ground. Move the grass trimmer from right to left slowly.
Cut the grass a few times from the top of the grass at
the tip of the nylon cord.
NOTICE:
Do not cut high grass at a time. Cutting
the high grass at a time near the root may cause the
nylon cutting head to be entangled by grass. This may
cause the motor overload, resulting in damage to the
grass trimmer.
NOTICE:
Use the grass trimmer without getting
the spool into a contact with the ground surface.
Using the spool contacting the ground surface may
cause the motor under overload resulting in damage
to the grass trimmer.
►
Fig.22
NOTICE:
Do not force the trimmer in densely
growing grass.
►
Fig.23
NOTICE:
Do not use the trimmer as if you dig out
the ground.
►
Fig.24
Cutting the grass near tree, block,
brick, or stone
Hold and tilt the grass trimmer at a height where the
spool does not touch the ground. Cut the grass using
the nylon cord tip like knocking the ground. ►
Fig.25
NOTICE:
When cutting the grass, move the grass
trimmer around the tree or blocks so that the
nylon cord does not touch the tree or blocks.
It is
recommended to keep the tool more than 5 cm away
from the tree or block. If the nylon cord touch the tree
or block, the nylon cord may be torn. If the nylon cord
is torn in the spool, set the nylon cord again referring
to the replacement procedure in this manual.
Using the grass trimmer as an
edger
Using the grass trimmer as an edger is suitable for
cutting the grass growing along the bricks or blocks.
Pull down the wire guard and rotate the grass trimmer
180°.
As shown in the figure,
while contacting the wire guard
with the ground, move the grass trimmer to cut the
grass.
You can cut the
grass efficiently by walking in
parallel along the bricks or blocks.
►
Fig.26:
1. Wire guard
WARNING:
Be extremely careful to maintain
control of the machine when detaching the
shoulder harness.
CAUTION:
Before operation, adjust the
shoulder harness to the proper length to prevent
fatigue.
CAUTION:
Be sure that the tool is held
securely by the shoulder harness before
operation.
The shoulder harness features a means of quick
release. Squeeze the sides of the buckle to release the
tool from the shoulder harness.
►
Fig.27: 1. Buckle