9 ENGLISH
●
Do not hold the power supply cable and plug by your
mouth. Doing so might cause an electric shock.
●
Do not touch the power plug with wet or greasy
hands.
●
Damaged or entangled cords increase the risk
of electric shock. If the cord is damaged, have it
replaced by our authorized service center in order to
avoid a safety hazard. Do not use it before repair.
●
After use, always store AC power adaptor out of the
reach of children. If Children play with the cord, they
may suffer injury.
Charging with USB power supply port
There is the USB port at the front side of the radio. You
can charge USB device through the USB port.
1. Press the Power button to switch on your radio.
2. Connect the USB device, such as a mobile phone,
with USB cable available in the market.
3. No matter if the radio is AC powered or battery
powered, the radio can charge the USB device when
the radio is switched on and in FM/DAB radio mode,
or BT mode, or AUX mode, which is appeared when
an external audio source is connected.
Note:
●
The maximum volume of the output power speaker
will decrease when your USB is charging.
●
The USB socket can provide max 5V/2.4A of
electrical current.
Important:
●
Before connecting USB device to the charger, always
backup your data of USB device. Otherwise your data
may lose by any possibility.
●
The charger may not supply power to some USB
devices.
●
When not using or after charging, remove the USB
cable and close the cover.
●
Do not connect power source to USB port. Otherwise
there is risk of fire. The USB port is only intended
for charging lower voltage device. Always place the
cover onto the USB port when not charging the lower
voltage device.
●
Do not insert a nail, wire, etc. into USB power supply
port. Otherwise a circuit short may cause smoke and
fire.
●
Do not connect this USB socket with your PC
USB port, as it is highly possible that it may cause
breakdown of the units.
LISTENING TO THE RADIO
This radio has three tuning methods- Scan tuning,
Manual tuning and Memory presets recall.
Selecting a station – DAB
Note:
The DAB antenna is built into the handle. When
operating the radio, please straighten the handle
properly above the radio to get better reception.
1. Press the Power button to switch on your radio.
2. Select the DAB mode by pressing the Band button.
3. Press the Advanced setting button and rotate the
Volume/Tuning Control/Select knob until “Station List”
is flashing on the screen. Press the Volume/Tuning
Control/Select knob to enter the list of the stations.
4. Rotate the Volume/Tuning Control/Select knob to
scroll through the list of available stations. Press the
knob to select the station.
5. Adjust the desired volume by rotating the Volume/
Tuning Control/Select knob.
Display modes – DAB
Your radio has a range of display options in the DAB
mode.
Press the Info button to cycle through the various
options shown in the following letters (a. to g.)
a. Station name
Indicates the station name being
listened to.
b. Program type
Indicates the type of station being
listened to. E.g. Pop, Classics,
News, etc.
c. Multiplex name Indicates the name of the DAB
multiplex to which the current
station belongs.
d. Time & date
Indicates the current time and date.
e. Frequency and
ch
channel
Indicates the frequency and channel
number for the currently tuned DAB
station.
f. Bit rate/Audio
ty
type
Indicates the digital audio bit rate
and audio type for the currently
tuned DAB station.
g. Signal strength Indicates the signal strength for the
currently tuned DAB station.
Finding new stations – DAB
From time to time, new DAB radio stations may become
available. Or you may have moved to a different part of
the country. In this case you may need to activate your
radio to scan for new stations.
To allow the radio to find the available stations, it is
recommended to carry out a full scan of the entire DAB
Band III frequencies.
1. Press the Auto tune button.
2. Your radio will perform a full scan of the DAB
frequencies. As new stations are found, the station
counter on the right side in the display will increase
and stations will be added to the list.
