R
epair
P 4/ 9
[3] -1. Angle Head Complete
[3] DISASSEMBLY/ASSEMBLY
DISASSEMBLING
1) Angle head complete can be removed from Housing simply by unscrewing (+) Hex bolt M5x30.
Note: If the overlapping portion of Angle head complete is deformed from abuse or a fall, Angle head complete cannot
be removed from Housing by hand. In this case, remove it while expanding the slit between the bolt holes
with a slotted screwdriver. (Fig. 2)
2) Remove Retaining ring R-26 using 1R005.
3) By striking Angle head complete straight against a flat surface of work bench or the like, the following parts can be
removed as an assembly (Fig. 3):
Zerol bevel gear 13, Ball bearing 6000, Sleeve 10, Ball bearing 6000LLB, Retaining ring S-10
4) Remove Retaining ring S-10 using 1R291, then two Ball bearings using 1R269.
5) Remove Rubber ring 32 from Angle head complete, then remove Retaining ring R-28 using 1R291.
6) Spindle section can now be removed by tapping Angle head complete.
Note: Spindle section cannot be removed if Angle head complete is deformed from abuse or a fall.
In this case, attach an appropriate bit on Angle head complete, then clamp the bit securely in a vise.
Spindle section can now be removed by tapping Angle head complete with plastic hammer as illustrated in Fig.. 4.
7) Spindle section can be disassembled as described in Fig. 5.
Fig. 3
Fig. 4
Fig. 2
Angle head complete
bit
vise
bolt hole
Angle head complete
assembly consisting of
Zerol bevel gear 13, etc
Angle head complete
Fig. 5
Zerol bevel gear 13
Ball bearing 6001DDW
Insert an awl between the teeth of Spindle
into Ring spring 9.
Note: Insert into the space on the opposite
side of the ends of Ring spring 9.
Hook Ring spring 9 by moving the awl
in the direction of the arrow.
Note: Ring spring 9 will be deformed when
removed from Spindle.
Be sure to use new one for assembling
1) Remove Ring spring 9 from Spindle
by taking the following steps:
2) Remove Zerol bevel gear 13 from Spindle
by striking Spindle straight against a flat
surface of work bench or the like.
If cannot be removed, remove together with
Ball bearing 6001DDW using 1R269
as illustrated below.
ends of Ring spring 9
teeth of Spindle
Zerol bevel gear 13
Ball bearing 6001DDW
Spindle
1R269
