R
epair
P 8 / 15
(4) Assembling slider
< Note > Pay attention to the following matters, before assembling slider section.
a. Make sure that the following parts are already installed on gear housing cover.
* Slide plate See Fig. 13
* 2 pcs. of plates 12x16 (made of felt) on the places for plane bearings See Fig. 13.
b. Apply machine oil #120 to plates 12x16. See Fig. 13.
c. Apply a bit of MAKITA grease N.No.1 to the inside of dust seal 14 where the slider reciprocates.
d. Apply 7g of MAKITA grease N No.1 to slider. See Fig. 13A.
Plates 12x16
Slide plate
Fig. 13
Dust seal 14
Fig. 13A
Slider
Apply 7g of MAKITA grease N No.1.
1. Pass slider through plane bearing 14 from the blade clamp side as illustrated in Fig.14. And then, pass the slider
through dust seal in gear housing cover. Assemble plane bearing 14 to the motor housing side of slider as
illustrated in Fig. 14A. And fit plane bearings 14 on plates 12 x16 (made of felt) respectively.
Fig.14
Fig.14A
Plane bearing 14
Motor housing side
Blade clamp side
Motor housing side
Blade clamp side
Plane bearing 14
Slider
Slider
Plates 12 x16
< Note >
Pay attention to the assembling direction of plane bearings 14, when they are assembled to slider. See Fig. 14B
The convex portions of plane bearings have to
face to the center of slider, each other.
The convex portions of plane bearings do not
face to the center of slider.
Fig.14B
