![background image](http://html.mh-extra.com/html/makita/makstar-bjr240sf/makstar-bjr240sf_technical-information_232403007.webp)
R
epair
P 7 / 15
5. Remove driving sleeve, and assemble the following parts to slider. See Fig. 11.
(7) Driving sleeve guide,
(6) Guide sleeve
(1) Shoulder pin 5 (Apply a bit of MAKITA grease N.No.1 to shoulder pin 5, when assembling it.)
(2) Compression spring 6
(5) Pin 3 (short)
1. Remove insulation cover, shoe and blade clamp section. Refer to (1) Removing shoe and
(2) Disassembling blade clamp section.
2. Unscrew 4 pcs. of pan head screws M5x18, and separate gear housing cover from gear housing, as illustrated in
Fig. 12.
3. Take off 2 pcs. of plates by unscrewing 4 pcs. of pan head screws M5x16. Remove plane bearing 14 of motor
housing side, from slider. See Fig. 12A.
Aligning the convex portion of driving guide with the concave portions of sleeve and driving sleeve guide,
assemble driving sleeve and fasten it with retaining ring S-18. See Fig. 11A.
Torsion spring 17
Sleeve
(5)
(2)
(1)
(7)
(6)
Driving sleeve
Retaining ring S-18
Fig. 11
Fig. 11A
(3) Disassembling slider
Pan head screws
M5x18
Gear housing
cover
Gear housing
Gasket
Fig. 12
Fig. 12A
Motor housing side
Blade clamp side
Plane
bearing 14
Plane
bearing 14
Slider
Pan head screw
M5x16
Pan head screw
M5x16
Plate
Plate
< Note > Use impact driver for loosening pan head screws M5x16 which are fastening plates, because it is
difficult to loosen them with hand due to the adhesive on pan head screws M5x16.
4. Pushing slider to the motor housing side, remove it from gear housing cover. See Fig. 12A.