Makita M9000, Инструкция по эксплуатации

Страница: 3 / 60

3
ENGLISH (Original instructions)
Explanation of general view
1-1. Shaft lock
2-1. Switch trigger
2-2. Lock lever
4-1. Wheel guard
4-2. Screw
4-3. Bearing box
5-1. Lock nut
5-2. Depressed center grinding wheel
5-3. Inner flange
6-1. Lock nut wrench
6-2. Shaft lock 8-1. Lock nut
8-2. Abrasive cut-off wheel/
diamond wheel
8-3. Inner flange
8-4. Wheel guard for abrasive cut-off
wheel/diamond wheel
9-1. Lock nut
9-2. Outer flange 78
9-3. Abrasive cut-off wheel/
diamond wheel
9-4. Inner flange 78
9-5. Wheel guard for abrasive cut-off
wheel/diamond wheel
10-1. Exhaust vent
10-2. Inhalation vent
11-1. Commutator
11-2. Insulating tip
11-3. Carbon brush
12-1. Brush holder cap
12-2. Screwdriver
SPECIFICATIONS
Model M9000 M9001
Depressed center wheel diameter 180 mm 230 mm
Max. wheel thickness 6.0 mm
Spindle thread M14 or 5/8" (country specific)
Rated speed (n) / No load speed (n
0
) 8,500 min
-1
6,600 min
-1
Overall length 466 mm
Net weight 5.4 kg 5.7 kg
Safety class /II
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE091-1
Intended use
The tool is intended for grinding and cutting of metal
and stone materials without the use of water.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
ENF100-1
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause
voltage fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.24 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected
with a fuse or protective circuit breaker having slow
tripping characteristics.
ENG905-1
Noise
The typical A-weighted noise level determined
according to EN60745:
Sound pressure level (L
pA
) : 90 dB (A)
Sound power level (L
WA
) : 101 dB (A)
Uncertainty (K) : 3 dB (A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Model M9000
Work mode : surface grinding
Vibration emission (a
h,AG
) : 5.0 m/s
2
Uncertainty (K) : 1.5 m/s
2
Model M9001
Work mode : surface grinding
Vibration emission (a
h,AG
) : 5.0 m/s
2
Uncertainty (K) : 1.5 m/s
2