15
1.
Press cutting (cutting small workpieces)
1
011409
Workpieces up to 91 mm high and 70 mm wide can
be cut in the following manner.
Push the carriage toward the guide fence fully and
tighten the locking screw clockwise to secure the
carriage. Secure the workpiece correctly with the
proper type of vise. Switch on the tool without the
blade making any contact and wait until the blade
attains full speed before lowering. Then gently
lower the handle to the fully lowered position to cut
the workpiece. When the cut is completed, switch
off the tool and WAIT UNTIL THE BLADE HAS
COME TO A COMPLETE STOP before returning
the blade to its fully elevated position.
WARNING:
•
Firmly tighten the knob clockwise so that the
carriage will not move during operation.
Insufficient tightening of the knob may cause
possible kickback which may result in serious
personal injury.
2.
Slide (push) cutting (cutting wide workpieces)
1
011410
Loosen the locking screw counterclockwise so that
the carriage can slide freely. Secure the workpiece
with the proper type of vise. Pull the carriage
toward you fully. Switch on the tool without the
blade making any contact and wait until the blade
attains full speed. Press the handle down and
PUSH THE CARRIAGE TOWARD THE GUIDE
FENCE AND THROUGH THE WORKPIECE.
When the cut is completed, switch off the tool and
WAIT UNTIL THE BLADE HAS COME TO A
COMPLETE STOP before returning the blade to its
fully elevated position.
WARNING:
•
Whenever performing a slide cut, first pull the
carriage full towards you and press the handle
all the way down, then push the carriage toward
the guide fence. Never start the cut with the
carriage not pulled fully toward you.
If you
perform the slide cut without the carriage pulled
fully toward you unexpected kickback may occur
and serious personal injury may result.
•
Never attempt to perform a slide cut by pulling
the carriage towards you.
Pulling the carriage
towards you while cutting may cause unexpected
kickback resulting in possible serious personal
injury.
•
Never perform the slide cut with the handle locked
in the lowered position.
•
Never loosen the locking screw which secures
the carriage while the blade is rotating.
A loose
carriage while cutting may cause unexpected
kickback resulting in possible in serious personal
injury.
1. Locking screw
1. Locking screw
