P 8/13
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Cylinder Section
R
epair
1) Assemble O ring 22 to Striker, then insert Striker into Cylinder B
as illustrated in Fig. 20.
2) Assemble Slide plate, Rubber ring 18 and Washer 17 to Cylinder A
by doing the reverse of the disassembling step 4) in page 7.
(Figs. 19 to 15)
Note: Slide plate is not reversible when assembled to Cylinder A.
The beveled side of the two protrusions of Slide plate must
face towards Tool holder side as illustrated in Fig. 21.
3) Assemble Cylinder B to Cylinder A. (Fig. 13 in page 6)
4) Assemble Slide sleeve and Ring 34 to the assembly
of Cylinder A and Cylinder B. (Fig. 22)
5) Do the reverse of the disassembling steps.
(Figs. 11 to 4 in pages 4, 5, 6)
Fig. 21
Cylinder A
Rubber ring 18
Slide plate
Washer 17
ASSEMBLING
[T
ool holder side]
[Cylinder B side]
[Tool holder side]
[Cylinder B side]
Fig. 20
O Ring 22
O ring 22 must be placed on
Crank housing complete side.
Cylinder B
Striker
[Cylinder
A side]
[Crank housing complete side]
Cross section
Rubber ring 18
Washer 17
Slide plate
beveled side
beveled side
beveled side
beveled side
protrusion
protrusion
protrusion
protrusion
Ring 34
Note:
Be sure to fit the two protrusions
of Slide plate in the corresponding
small notches, not large ones,
of Slide sleeve.
protrusion of Slide plate
small notch
Fig. 22
Slide sleeve
Cylinder A
Cylinder B
large notch
