Makita HP1510, Инструкция по эксплуатации

Страница: 6 / 12

6
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing side grip (auxiliary handle)
Always use the side grip to ensure operating safety. Install the side grip on the
tool barrel. Then tighten the grip by turning clockwise at the desired position. It
may be swung 360 ° so as to be secured at any position.
NOTE:
The side grip cannot swing 360 ° when the depth gauge is installed.
Installing or removing drill bit
For Model HP1501
Hold the ring and turn the sleeve counterclockwise to open the chuck jaws.
Place the bit in the chuck as far as it will go. Hold the ring firmly and turn the
sleeve clockwise to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve counterclockwise.
For Model HP1500,HP1510
To install the bit, place it in the chuck as far as it will go. Tighten the chuck by
hand. Place the chuck key in each of the three holes and tighten clockwise. Be
sure to tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in just one hole, then
loosen the chuck by hand.
After using the chuck key, be sure to return to the original position.
1. Grip base
2. Side grip
1
2
002416
1. Ring
2. Sleeve
1
2
002456
1. Chuck key
2. Chuck
1
2
002454