P 3/ 11
R
epair
[4] DISASSEMBLY/ASSEMBLY
[4]-1. Armature, Small spiral bevel gear, Ball bearing 6301DDW
DISASSEMBLING
5x35 Tapping screw
(4pcs.)
(1) Disassemble Armature and Spiral bevel gear (small) as illustrated in
Figs. 2
and
3
.
(2) Disassemble Ball bearing 6301DDW as illustrated in
Figs. 4 and 5
.
M6x22 Hex socket head bolt (4pcs.)
Brush holder cap
Carbon brush
Armature
Turn Armature counterclockwise while
holding M8 Hex nut with Wrench 13.
M8 Hex nut can be removed.
Remove Carbon brushes. And then
remove 5x35 Tapping screws.
Remove Gear housing complete
together with Armature.
Remove Bearing box and M6x22
Hex socket head bolts.
Wrench 13 for locking M8 Hex nut
M8 Hex nut
Pull off Armature while
holding Small spiral bevel gear.
Small spiral
bevel gear
Armature
Fig. 2
Fig. 3
Remove Retaining ring R-42 with 1R005,
then remove Flat washer 20.
Fig. 4
Fig. 5
Retaining ring
R-42
Flat washer 20
Ball bearing 6301DDW
M8 Hex nut
Ball bearing 6301DDW
Felt ring 18 (a component of Gear housing complete)
Rubber ring 38
Gear housing complete
Set Armature and Small spiral bevel gear to Gear housing complete.
And set M8 hex nut in place temporarily by reversing the step of
Fig. 3.
Tap the end of Gear housing complete with a plastic hammer.
Ball bearing 6301DDW can be removed from Rubber ring 38 in
Gear housing complete. Felt ring 18 falls off at that time.
Gear housing complete
Note
: If the above work is very difficult
due to the seizing of Small spiral
bevel gear, spray a lubricant
between Armature shaft and Small
spiral bevel gear. And then turn
and pull Armature while holding
Small spiral bevel gear with pliers
and a cloth.
Small spiral bevel gear
