Makita GA7012C, Инструкция по эксплуатации

Страница: 5 / 80

5
ENGLISH
(Original instructions)
Explanation of general view
1 Shaft lock
2 Switch trigger
3 Lock lever
4 Indication lamp
5 Side grip
6 Wheel guard
7 Screw
8 Bearing box
9 Nut
10 Lever
11 Lock nut
12 Depressed center grinding
wheel/Multi-disc
13 Inner flange
14 Super flange
15 Depressed center wheel/
Multi disc
16 Lock nut wrench
17 Shaft lock
18 Abrasive disc
19 Rubber pad
20 Wire cup brush
21 Wire wheel brush
22 Abrasive cut-off wheel/diamond
wheel
23 Wheel guard for abrasive cut-off
wheel/diamond wheel
24 Outer flange 78
25 Inner flange 78
26 Exhaust vent
27 Inhalation vent
28 Commutator
29 Insulating tip
30 Carbon brush
31 Screwdriver
32 Brush holder cap
SPECIFICATIONS
Model GA7012C GA9012C
Depressed center wheel diameter................................................180 mm 230 mm
Spindle thread ..............................................................................M14 M14
No load speed (n
0
) / Rated speed (n)...........................................8,400 min
–1
6,000 min
–1
Overall length ...............................................................................453 mm 453 mm
Net weight.....................................................................................4.3 kg 4.5 kg
Safety class .................................................................................. /II /II
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
GEA010-1
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
GEB033-3
GRINDER SAFETY WARNINGS
Safety Warnings Common for Grinding, Sanding,
Wire Brushing, or Abrasive Cutting-Off Operations:
1.
This power tool is intended to function as a
grinder, sander, wire brush or cut-off tool. Read
all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
2. Operations such as polishing are not recom-
mended to be performed with this power tool.
Operations for which the power tool was not
designed may create a hazard and cause personal
injury.
3. Do not use accessories which are not specifi-
cally designed and recommended by the tool
manufacturer.
Just because the accessory can be
attached to your power tool, it does not assure safe
operation.
4. The rated speed of the accessory must be at
least equal to the maximum speed marked on
the power tool.
Accessories running faster than
their rated speed can break and fly apart.
5. The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool.
Incorrectly sized accessories can-
not be adequately guarded or controlled .
6. The arbour size of wheels, flanges, backing pads
or any other accessory must properly fit the
spindle of the power tool.
Accessories with arbour
holes that do not match the mounting hardware of
the power tool will run out of balance, vibrate exces-
sively and may cause loss of control.