27
Troubleshooting
Malfunction
System
Observation
Cause
Cutting disc does not
start turning
Clutch
Engine runs
Damage to clutch
Cutting disc runs in idle
Carburetor,
Cutting disc runs
Incorrect idle speed,
clutch
blocked clutch
V-belt
Belt has insufficient tension, V-belt is worn
Engine does not start or
Ignition system
Ignition spark
Malfunction in fuel supply system, com-
only with difficulty
pression system, mechanical malfunction.
No ignition spark
Switch on STOP, fault or short-circuit in the
wiring, plug cap or spark plug defective.
Fuel supply
Fuel tank is filled
Choke in wrong position, carburetor defective,
suction head dirty, fuel line bent or interrupted.
Compression
Inside
Cylinder base packing ring defective, radial
system
shaft packings defective, cylinder or piston rings
defective
Outside
Spark plug does not seal.
Mechanical
Starter does not engage
Spring in starter broken, broken parts
malfunction
inside the engine.
Warm start difficulties
Carburetor
Fuel tank is filled
Wrong carburetor adjustment.
Ignition spark
Engine starts, but
Fuel supply
Fuel tank is filled
Wrong idling adjustment, suction head or
dies immediately
carburetor dirty.
Tank venting defective, fuel line interrupted,
cable defective, STOP switch defective.
Decompression valve dirty
Insufficient power
Several systems
Engine is idling
Air filter dirty, wrong carburetor adjustment,
may be involved
muffler clogged, exhaust channel in cylinder
simultaneously
clogged, spark arrester screen clogged.
Diamond cutting discs
MAKITA diamond cutting discs meet the highest demands
in working safety, ease of operation, and economical cut-
ting performance. They can be used for cutting all materials
except metal
.
The high durability of the diamond grains ensures low wear
and thereby a very long service life with almost no change in
disc diameter over the lifetime of the disc. This gives consistent
cutting performance and thus high economy. The outstanding
cutting qualities of the discs make cutting easier.
The metal disc plates give highly concentric running for minimal
vibration during use.
The use of diamond cutting discs reduces cutting time sig-
nificantly. This in turn leads to lower operating costs (fuel
consumption, wear on parts, repairs, and last but not least
environmental damage).
SPECIAL ACCESSORIES
Pressurized water tank
To keep down dust and for better cutting-disc cooling, MAKITA
offers several options for wetting the disc during operation.
The pressurized water tank is connected to the Power Cut by
the water set on the protective hood.
See “Accessories” for order number.