P 7/ 35
Assembly
(1) Tighten the four fan fixing screws in a criss-cross pattern (the order shown in
Fig. 8
).
(2) Screw Compression springs 22 all the way onto Spring holders. The two shorter ones should be at the top (of Rear volute case) and the
two longer ones should be at the bottom (of Front volute case). (
Fig. 6
)
If Rubber rings at the bottom have been removed, attach them as shown in the photo on the right of
Fig. 9
and then screw the springs
onto Spring holders.
(3) Attach Elbow (a) with the protrusion positioned as shown in
Fig. 9
so that you can rotate Elbow from the front
of the machine and then secure Rear volute case (b) with eleven Tapping screws 5. (
Fig. 7
)
(4) Attach Frame, then connect Carburetor to Control cable, then connect the bullet terminals and earth wire of
Ignition coil and then secure Guard. (
Figs. 4
and
5
)
Place the bullet terminals in place as shown in Fig. 5 (d) while taking care that it will not become pinched
in the engine cover. Place corrugated tube (c) of Model EB7650TH in place as shown in
Fig. 10
.
Protrusion
(b)
Slide Rubber ring all the way onto each
Spring holder with the flanged end of the
ring facing Front volute case.
(a)
(c)
Place the bullet terminals and
line filter in this space, if used.
Fig. 9
Fig. 10
Makita Corporation
