11
Remaining battery capacity indication
(Country specific)
Fig.3
Press the check button to make the battery indicators
show the remaining battery capacities. The battery
indicators correspond to each battery.
Remaining battery capacity indication
Battery indicator status
Remaining battery capacity
50
%
- 100
%
20
%
- 50
%
0
%
- 20
%
C
harge the battery
O
n
O
ff
Blinking
015452
Power switch action
WARNING:
•
Before inserting the battery cartridge into the
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
Operating a tool with a
switch that does not actuate properly can lead to
loss of control and serious personal injury.
Fig.4
Press and hold the main power button for some
seconds to turn on the tool.
To turn off the tool, press and hold the main power
button again.
Fig.5
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided.
To start the tool, grasp the rear handle (the lock-off lever
is released by the grasp) and then pull the switch trigger.
To stop the tool, release the switch trigger.
NOTE:
•
The tool is automatically turned off after the tool is
left one minute without any operations.
Speed adjusting
Fig.6
You can adjust the tool speed by tapping the main
power button.
Each time you tap the main power button,
indicator
or
indicator lights up.
is for high speed and
for low speed.
Reverse button for debris removal
WARNING:
•
Switch off the tool and remove the battery
cartridge before you remove entangled weeds
or debris which the reverse rotation function
can not remove.
Failure to switch off and remove
the battery cartridge may result in serious personal
injury from accidental start-up.
Fig.7
This tool has a reverse button to change the direction of
rotation. It is only for removing weeds and debris
entangled in the tool.
To reverse the rotation, tap the reverse button and pull
the trigger when the tool's head is stopped. The power
lamp starts blinking, and the tool's head rotates in
reverse direction when you pull the switch trigger.
To return to regular rotation, release the trigger and wait
until the tool's head stops.
NOTE:
•
During the reverse rotation, the tool operates only
for a short period of time and then automatically
stops.
•
Once the tool is stopped, the rotation returns to
regular direction when you start the tool again.
•
If you tap the reverse button while the tool's head
is still rotating, the tool comes to stop and to be
ready for reverse rotation.
Nylon cutting head (optional accessory)
NOTICE:
•
The bump feed will not operate properly if the
head is not rotating.
Fig.8
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while rotating.
NOTE:
If the nylon cord does not feed out while bumping the
head, rewind/replace the nylon cord by following the
procedures described under "Maintenance".
ASSEMBLY
WARNING:
•
Always be sure that the tool is switched off and
battery cartridge is removed before carrying out
any work on the tool.
Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
•
Never start the tool unless it is completely
assembled.
Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Содержание DUR364L
Страница 102: ...102 ...
Страница 103: ...103 ...
Страница 104: ...104 www makita com Makita Jan Baptist Vinkstraat 2 3070 Belgium Makita Corporation Anjo Aichi Japan 885388E970 ...