![background image](http://html1.mh-extra.com/html/makita/dup362/dup362_instruction-manual_4007832011.webp)
11 ENGLISH
5.
First, align the triangular marks of the female socket of the
connection cord with the triangular mark of the male connector of
the shears. Push in the socket of the connection cord to the con-
nector of the shears. Then, align the marking on the coupling with
the trianglar marks, and push in and turn the coupling to tighten.
2
1
4
1
3
5
►
1.
Triangular mark
2.
Connection cord
3.
Shears
4.
Marking on coupling
5.
Coupling
NOTICE:
Turn the coupling and align the marking
on the coupling with the triangular marks first when
disconnecting the connection cable.
Putting shears in the holster
Keep pulling the switch trigger to close the shear blades, and press
the I/O switch to "O" side to turn off the tool. Then put the shears
into the holster and hold the shears with the strap of the holster.
OPERATION
CAUTION:
Always hold the tool firmly. And
keep firm footing.
CAUTION:
Do not put any of your body parts
near to the blades during operation.
CAUTION:
Before use, inspect if the blades,
blade bolts or other parts are not worn or damaged.
Replace worn or damaged parts for safe operation.
NOTICE:
If the blade is stuck in a branch during
operation, do not twist the blade. In that situation, turn
off the tool and pull the blades straight out slowly from
the branch. Otherwise the blade may be damaged.
NOTICE:
In case you cut too thick branch or something too
hard, the overload protection works and the tool stops. In that
situation, if the upper shear blade is opened too wide and the
switch trigger is pulled fully, the upper blade closes slightly when
you press the I/O switch to “I” (on) position for restarting the tool.
Pruning operation
Cut branches one by one. The maximum thickness of
branches which can be cut with these shears is about
33mm. Maintain your proper footing and balance at all times.
After use
Close the shear blades, press the I/O switch to the “O” (off) posi-
tion, and disconnect the connection cord from the shears and the
switch box, and remove the batteries from battery holder.
Store the shears in dry, high or locked-up place – out of
reach of children.
NOTICE:
Remove the battery when not using the
shears.
Otherwise the battery capacity is reduced
during course of time.
Catcher
Optional accessory
The catcher is useful, when picking flowers. It temporar
-
ily holds picked flower after cutting.
If the clearance between the catcher and lower blade
is not appropriate for your application, adjust the clear
-
ance by loosening the screws.
1
1
2
2
►
1.
Catcher
2.
Screw