Makita DUP361, Инструкция по эксплуатации

Страница: 20 / 131

20 ENGLISH
Putting shears in the holster
Keep pulling the switch trigger to close the shear
blades, and press the I/O
switch to "O" side to
turn off the tool. Then put the shears
into the holster and hold the shears with the strap of the
holster.
OPERATION
CAUTION:
Always hold the tool firmly. And
keep firm footing.
CAUTION:
Do not put any of your body parts
near to the blades during operation.
CAUTION:
Before use, inspect if the blades,
blade bolts or other parts are not worn or
damaged.
Replace worn or damaged parts for safe
operation.
NOTICE:
If the blade is
stuck in a branch
during operation, do not
twist the blade. In
that situation, turn off
the tool and pull
the blades straight out
slowly from the branch.
Otherwise the blade may
be damaged.
NOTICE:
In case you cut
too thick branch or
something too hard, the overload protection
works and the tool stops. In that
situation, if the upper
shear blade is opened
too wide and the switch trigger is pulled fully, the
upper blade closes slightly
when you press the
I/O switch to “I” (on) position for restarting
the tool.
Pruning operation
►
Fig.21
Cut branches one by one.
The maximum thickness of branches
which can be cut with
these shears is about
33mm. Maintain your proper footing
and balance at all times.
After use
Close the shear blades, press
the I/O switch to the
“O”
(off) position, and disconnect the connection
cord from the shears and the
switch box, and remove the
batteries from battery holder.
Store the shears in dry, high or locked-up place
– out of
reach of children.
NOTICE:
Remove the battery when not using the
shears. Otherwise the battery capacity
is reduced during course of
time.
Catcher
Optional accessory
The catcher is useful, when
picking flowers. It temporarily holds
picked flower after cutting.
If the clearance between the
catcher and lower blade is
not appropriate for your
application, adjust the clearance by
loosening the
screws. ►
Fig.22: 1.
Catcher 2. Screw
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
CAUTION:
Wear safety gloves when handling
the blade. Otherwise it may result
in personal injury.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Blade maintenance
NOTICE:
Failure to perform blade
maintenance may cause
excessive blade friction and
shorten the operating time
per battery charge.
Before and after operation, check
the shear blades carefully.
After operation, clean off the
blades with a stiff brush.
Then wipe the blades with
a cloth. And apply Makita
genuine machine oil onto the
blade edge and movable
part. ►
Fig.23
Sharpening blades