Makita DTS141Y1J, Инструкция по эксплуатации

Страница: 7 / 68

7
• For approximately 10 seconds after releasing the
switch trigger, the lamp status can be changed.
Reversing switch action (Fig. 5)
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool comes to a
complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
• When not operating the tool, always set the reversing
switch lever to the neutral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
Characteristics of Cordless Oil-impulse Driver
The Makita Cordless Oil-impulse Driver is a hydraulically
operated impact tool using oil viscosity to produce
impacts. Since oil viscosity changes with the
temperature, be aware of the following two points when
operating the tool.
1.
Avoid using the tool below –10°C (14°F) of
temperature. When the tool temperature goes down
below the degrees, this may cause damage to the
motor of tool due to poor impulse.
2. When the tool becomes too hot, it may take longer to
set screws.
3. The tool can overheat, causing a failure or hand
burn if you operate it continuously for long hours. Let
the tool cool off for more than 30 minutes before
changing batteries during a long, continuous job.
Changing the impact force (Fig. 6)
015147
The impact force can be changed in four steps: hard,
medium, soft, and T mode.
This allows a tightening suitable to the work.
Every time the button
is pressed, the number of
blows changes in four steps.
For approximately one minute after releasing the switch
trigger, the impact force can be changed.
“T” is a special mode for fastening self drilling screws and
bolts. In this mode, the tool starts to drive a screw with
faster rotation, which is suited for drilling with the self-
drilling-screw tip. Once the tool starts to tighten the
screw, it impacts in soft force grade.
NOTE:
• When all lamps on the switch panel go out, the tool is
turned off to save the battery power. The impact force
grade can be checked by pulling the switch trigger to
the extent that the tool does not operate.
• While pulling the switch trigger, the impact force grade
cannot be changed.
• The tool automatically stops to prevent the damages on
the parts during heavy load operation with hard or
medium impact force grade. In that case select the soft
or T mode impact force grade.
Impact force grade
displayed on panel
Maximum blows
Application Work
DTS131 DTS141
Hard
2,500
(min
–1
)
2,700
(min
–1
)
Tightening when force and
speed are desired.
Tightening in underwork
material / Tightening long
screws.
Medium
2,200
(min
–1
)
2,200
(min
–1
)
Tightening when a good
finishing is needed. Tightening in the finishing
board, plaster board.
Soft
1,400
(min
–1
)
1,400
(min
–1
)
Tightening when excessive
tightening need to be avoided
because of potentially
clogged female screw and
broken or damaged screw
head.
Tightening sash screw/
Tightening small screws such
as M6.
Tightening bolt up to M8.
T mode
1,400
(min
–1
)
1,400
(min
–1
)
Tightening when speed and
good finishing are needed.
Tightening when speed and
good finishing are needed.
Tightening bolt up to M8.