18 ENGLISH
To turn on the light, press the upper position (I) of the
lamp switch. To turn off the light, press the lower posi
-
tion (0) of the lamp switch.
2
1
►
1.
Lamp
2.
Lamp switch
NOTE:
Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE:
Be sure to turn off the lamp switch after use
because turning on the light consumes the battery
power.
Laser beam action
CAUTION:
Never look into the laser beam.
Direct laser beam may injure your eyes.
To turn on the laser beam, press the upper position (I)
of the switch. To turn off the laser beam, press the lower
position (0) of the switch.
1
►
1.
Laser switch
NOTE:
Be sure to turn off the switch as turning on the
switch consumes the battery power.
Laser line can be shifted to either the left or right side
of the circular saw blade by turning the adjusting screw
as follows.
1
►
1.
Adjusting screw
1.
Loosen the adjusting screw by turning it
counterclockwise.
2.
With the adjusting screw loosened, slide the
adjusting screw to the right or left as far as it goes.
3.
Tighten the adjusting screw firmly at the position
where it stops sliding.
NOTE:
Laser line is factory adjusted so that it is
positioned within 1 mm from the side surface of the
circular saw blade (cutting position).
NOTE:
When laser line appears dim and hard to see
because of direct sunlight, relocate the work area to a
place where there is less direct sunlight.
Aligning the laser line
Align the cutting line on your workpiece with the laser
line.
A
B
A) When you want to obtain the correct size on the left
side of workpiece, shift the laser line to the left of the
circular saw blade.
B) When you want to obtain the correct size on the right
side of workpiece, shift the laser line to the right of the
circular saw blade.
Electronic function
Soft start feature
This function allows the smooth start-up of the tool by
limiting the start-up torque.
