14 ENGLISH
5.
Pull the carriage toward you fully.
6.
Adjust the kerf boards so that the kerf boards just
contact the sides of the blade teeth.
1
1
1
2
2 2
3
3
3
4
5
6
►
1.
Saw blade
2.
Blade teeth
3.
Kerf board
4.
Left
bevel cut
5.
Straight cut
6.
Right bevel cut
7.
Tighten the front screws (do not tighten firmly).
8.
Push the carriage toward the guide fence fully and
adjust the kerf boards so that the kerf boards just con
-
tact the sides of blade teeth.
9.
Tighten the rear screws (do not tighten firmly).
10.
After adjusting the kerf boards, release the stop
-
per lever and raise the handle. Then tighten all the
screws securely.
NOTICE:
After setting the bevel angle, ensure
that the kerf boards are adjusted properly.
Correct
adjustment of the kerf boards helps to provide proper
support of the workpiece and minimizing workpiece
tear out.
Maintaining maximum cutting
capacity
This tool is factory adjusted to provide the maximum
cutting capacity for a 165 mm saw blade.
When installing a new circular saw blade, always check
the lower limit position of the circular saw blade, and if
necessary, adjust it as follows:
1.
Remove the battery cartridge. Then, push the car-
riage toward the guide fence fully and lower the handle
completely.
1
2
►
1.
Adjusting bolt
2.
Guide fence
2.
Use the hex wrench to turn the adjusting bolt until
the circular saw blade comes slightly below the cross
section of the guide fence and the top surface of the
turn base.
