Makita DLS112, Инструкция по эксплуатации, Страница: 26 / 32

26 ENGLISH
1
2
► 1. Guide fence 2. Crown molding stopper
(a) (b) (c) (d)
1 2
1. Inside corner 2. Outside corner
Table (C)
– Molding
position in
the figure
Miter angle Finished
piece
For inside
corner
(a) Right 45° Save the right
side of blade
(b) Left 45° Save the left
side of blade
For outside
corner
(c) Save the right
side of blade
(d) Right 45° Save the left
side of blade
Cutting aluminum extrusion
1
5
3
4
2
► 1. Vise 2. Spacer block 3. Guide fence 4. Aluminum
extrusion
5.
Spacer block
When securing aluminum extrusions, use spacer blocks
or pieces of scrap as shown in the figure to prevent
deformation of the aluminum. Use a cutting lubricant
when cutting the aluminum extrusion to prevent build-up
of the aluminum material on the blade.
WARNING:
Never attempt to cut thick or
round aluminum extrusions.
Thick or round alumi -
num extrusions can be difficult to secure and the work
may loosen during the cutting operation which may
result in loss of control and serious personal injury.
Groove cutting
WARNING:
Do not attempt to perform this
type of cut by using a wider type blade or dado
blade. Attempting to make a groove cut with a wider
blade or dado blade could lead to unexpected cutting
results and kickback which may result in serious
personal injury.
WARNING:
Be sure to return the stopper arm
to the original position when performing other
than groove cutting. Attempting to make cuts with
the stopper arm in the incorrect position could lead to
unexpected cutting results and kickback which may
result in serious personal injury.
For a dado type cut, perform as follows:
1. Adjust the lower limit position of the blade using
the adjusting screw and the stopper arm to limit the cut -
ting depth of the blade. Refer to "Stopper arm" section
described on previously.
2. After adjusting the lower limit position of the blade,
cut parallel grooves across the width of the workpiece
using a slide (push) cut.