Fig. 7-3
Wiring to Handle
Approx. 30°
Switch
Connect Insulated connector
to Switch as shown in the
figure on the right.
Put Brush holder’s Lead wires
into these lead wire holders.
Put Line filter (if used) into this
space between Rib I and Rib J.
Rib J
Rib I
Boss
Rib G
Rib E
Rib J
Route the lead wires from
Terminal and the lead wires
from FET between Rib A
and Boss.
Rib A
Rib D
Rib B
Rib C
Route the lead wire (red) from
Terminal between Rib B and Rib C.
Terminal
Rib F
Route the lead wire (yellow) from
Terminal and the lead wires from
FET between Rib D and Rib J.
Route the lead wires from FET
between Rib E and Rib F.
Rib H
Route the lead wires from
FET between Rib G and
Rib H.
FET
22 / 22
