5-2-2
Assembling
Fig. 5-2-2-1
[1] Assemble Torsion spring 17 to
Sleeve by inserting its short tail into
the hole of Sleeve.
Fig. 5-2-2-2
[2] Set Sleeve by passing the long tail of Torsion spring 17 through the slit of
Slider.
Fig. 5-2-2-4
[4] Mount Guide sleeve temporarily, then Put Compression
spring 2 and Push plate into the slit of Slider.
Hole where
Pin 3 is
installed
Note:
Face the short tail of Torsion spring 17
to the hole where Pin 3 is installed.
Sleeve
Short tail of
Torsion spring 17
Long tail of
Torsion spring 17
Fig. 5-2-2-3
[3] Turn Sleeve clockwise and insert Pin 3 into the hole
temporarily as shown below.
Sleeve
Pin 3
Compression spring 2
Guide sleeve
Push plate
Fig. 5-2-2-5
[5] While pushing Push plate straight into Slider with Recipro sawblade, insert pin 3 through the hole of Push plate as shown
below. Then remove Guide sleeve.
Note
: Guide sleeve is used as a jig. Do not assemble it to Slider in this step.
Recipro saw
blade
Guide sleeve
Pin 3
Hole of Push
plate
9 / 22
