2. Lock Switch lever complete
with an insulating tape or a like.
[4] TROUBLE SHOOTING (cont.)
Test for recognizing the short-circuit of FET* on controller
Fig. T-3
Remove Battery, and then do as shown in
Fig. T-3
.
3. Attach the black bar to (+) Terminal,
and the red bar to (-) Terminal.
Note
: Be careful not to reverse them.
The reverse attachment could spoil the test.
Wait until the display shows the value without
fluctuation.
(+) Terminal
(-) Terminal
Insulating tape
Switch lever complete
black bar
red bar
P 9/ 11
1. Set Digital tester (1R402) in the diode mode ( mark).
*FET: Field effect transistor
R
epair
**It includes Controller.
4. There is no fault of FET on Controller if the display
indicates
between 0.79V and 0.81V
.
If the display indicates
0V or 0.4V approximately
,
FET built in Controller has any trouble,
and Stator complete** has to be replaced.