Makita DFR450ZX, Инструкция по эксплуатации

Страница: 7 / 48

7
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the bit
Loosen the thumb screws which secure the casing. Pull
out the casing in the direction of the arrow.
Fig.7
Press the dust cover toward the plane bearing and pull
out the bit. If the dust cover cannot be moved as far as
the plane bearing, try it again after turning the bit slightly.
To install the bit, insert it into the socket while turning it
slightly. After installing, always make sure that the bit is
securely held in place by trying to pull it out.
Fig.8
Installing screw strip
Fig.9
Fig.10
Insert the screw strip through the screw guide. Then
insert it through the feeder box until the first screw
reaches the position next to the driving position.
Removing screw strip
To remove the screw strip, just pull it out in the direction
of the arrow.
Fig.11
If you depress the reverse button, you can pull out the
screw strip in the reverse direction of the arrow.
Fig.12
Carry hook
The carry hook is convenient for temporarily hooking the
tool. It can be installed on either side of the tool.
When removing the carry hook, widen it by pressing its
right ends ON BOTH SIDES in the directions of arrow
(1) and raise it in the direction of the arrow (2).
Fig.13
OPERATION
Driving operation
Fig.14
Switch on the tool by pulling the switch trigger. Hold the
tool squarely and firmly up against the driving surface. A
screw will be automatically carried to the driving position
and fastened.
CAUTION:
•
Always check the bit carefully for wear before
driving operations. Replace a worn bit or poor
fastening may result.
•
Always hold the tool squarely against the driving
surface. Holding it at an angle may damage the
screw heads and cause wear on the bit. This may
also lead to poor fastening.
•
Always keep the tool firmly against the driving
surface until the driving is over. Failure to do so
may cause insufficient fastening of screws.
•
Be careful not to drive a screw onto another screw
already fastened.
•
Do not operate the tool without screws. It will
damage the driving surface.
•
If the feeder box does not work smoothly when
driving screws, spray car wax (spray type) on the
sliding surfaces. Never lubricate it.
Driving in corner
Fig.15
This tool can be used to drive at a position 15 mm away
from the wall as shown in the figure.
CAUTION:
•
Driving at a position closer than 15 mm to the
wall or driving with the stopper base in contact
with the wall may damage the screw heads and
cause wear on the bit. This may also lead to poor
fastening of screws and malfunction of the tool.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before attempting to
perform inspection or maintenance.
•
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
Fig.16
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Loosen the thumb screws which secure the casing. Pull
out the casing in the direction of the arrow.
Fig.17
Use a screwdriver to remove two screws then remove
the front cover.
Fig.18
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit
screwdriver of slender shaft or the like.
Fig.19
Use pliers to remove the carbon brush caps of the carbon
brushes. Take out the worn carbon brushes, insert the
new ones and replace the carbon brush caps in reverse.