Makita DDG461Z, Инструкция по эксплуатации

Страница: 5 / 88

5 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model: DDG461
No load speed High 0 - 1,400 min
-1
Low 0 - 350 min
-1
Drilling capacities
(Diameter)
High For sandy soil: ø60 mm
For clay soil: ø60 mm
Low For sandy soil: ø200 mm
For clay soil: ø150 mm
Overall length 840 mm
*1
Rated voltage D.C. 36 V
Net weight 7.0 - 7.6 kg
*1
With side handle
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi -
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
Charger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
DC18SH / DC18WC
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Recommended cord connected power source
Portable power pack PDC01 / PDC1200
• The cord connected power source(s) listed above may not be available depending on your region of residence.
• Before using the cord connected power source, read instruction and cautionary markings on them.
Intended use
The tool is intended for drilling the ground.
Noise
The typical A-weighted noise level determined accord -
ing to EN62841-2-1:
Measured based on the intended use
Sound pressure level (L
pA
) : 84 dB (A)
Sound power level (L
WA
) : 95 dB (A)
Uncertainty (K) : 3 dB (A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the tool is
used especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima -
tion of exposure in the actual conditions of use (tak -
ing account of all parts of the operating cycle such
as the times when the tool is switched off and when
it is running idle in addition to the trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter -
mined according to EN62841-1:
Measured based on the intended use
Vibration emission (a
h,D
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2