P
9
/1
0
Fig. D-4
W
iring diagram
Fig. D-5
Battery capacity
warning lamp
plus
Terminal of DC Motor
with
a red dot
for identification
minus
Terminal of DC Motor
Flag terminal
Connect each Flag terminal of Controller with
the corresponding Terminal of DC Motor.
Important:
•
The wire connecting portion of
each Flag terminal must be placed
on Handle cover side.
•
Connect the Flag terminal on
red
lead wire
with
plus terminal
of DC Motor.
Line filter
(if used)
wire connecting
portion
rib
wall of Motor housing
Lead wire (black)
Lead wire (red)
Wiring in Motor Housing
Connecting Controller with DC Motor
Controller
Line filter (if used)
boss
Battery capacity
warning lamp
Put Battery capacity warning lamp in this groove
with the black Lead wire on the top.
After connecting the Connector of LED light circuit with
that of Controller unit, put the Connectors and the Lead wires
between the two ribs and the wall of Motor housing.
Fix Switch with this hook.
Do not route any Lead wire
over these ribs.
Route the Lead wires of
Controller unit between
the boss and Switch box.
Put Line filter in this place
if it is used.
Line filter (if used)
Put Line filter in this place
if it is used.
Route three Lead wires
(1 red, 1 blue, 1 white)
connecting Controller
and Dial in this groove.
Dial
Switch
Connector of
LED Light circuit
Connector of
Controller unit
