![background image](http://html1.mh-extra.com/html/makita/bss500z/bss500z_technical-information_3895307010.webp)
P 10/14
[3] DISASSEMBLY/ASSEMBLY
[3] -4. Armature (cont.)
[3] -5. Lock Off Lever and Switch Lever
2) Install Endbell complete on the commutator end of Armature. (Fig. 28)
3) Assemble Motor assembly (consisting of Armature, Yoke unit and Endbell complete) to Housing L. (Fig. 29)
4) Do the reverse of disassembling steps. (Figs. 23 and 24)
Note: Make sure that Shaft lock is set in place before assembling Gear housing to Motor section.
Fit the two ribs on the inside surface
of Housing L in the notch in Yoke unit
when installing Motor assembly to
Housing L.
notch
Yoke unit
Fig. 28
Fig. 29
Fig. 30
Housing L
Lock off lever
Switch lever
Switch lever
Compression spring 4
Assemble Lock off lever and Switch lever to Handle L. (Fig. 30)
Note: The same Compression spring 4 is used for Lock off lever and Switch lever.
Compression spring 4
Handle L
Compression spring 4
Insert Compression spring 4 over the boss
on the back of Lock off lever until it stops.
Insert Compression spring 4 over the boss
on the back of Switch lever until it stops.
Switch
R
epair
ASSEMBLING
Brush holder of Endbell
notch
For easy assembling, it is recommended
to align the center line of Brush holder
with that of notch in Yoke unit in this step.
two ribs
Lock off lever