![background image](http://html2.mh-extra.com/html/makita/bmr101/bmr101_original-instructions-manual_3990090003.webp)
Power supply
The machine shall only be connected to the voltage stated on the type plate and it
only works with single-phase AC voltage. It is provided with double protective
insulation according to European standards and thus, it may be also connected to
sockets without ground cable.
Do only use extension cables with sufficient cross section. A cross section that is
too small may lead to excessive loss of power and overheating of the tool and the
cable.
Safety Instructions
WARNING!
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions for future reference.
ADDITIONAL SAFETY RULES FOR THIS MACHINE:
1. If the connecting cable is damaged or cut during work, do not touch it and
immediately disconnect the power plug. In any case, do not work with the
tool if the connecting cable is damaged.
2. The tool should not be humid and it should not be operated in a humid
environment.
3. Do not use the tool to mix explosive or easily inflammable substances and
do not use it in areas close to these substances.
4. Do not use the cable to carry the tool.
5. Do always inspect the tool, the cable and the plug before using it. Repairs
shall only be carried out by an expert. The plug shall only be connected to
the socket if the tool is switched off.
6. Do only operate the tool outdoor with a residual current circuit breaker with
a maximum of 30 mA.
7. Do not leave the hand-held mixer running unattended.
8. Do disconnect the power plug and check if the hand-held mixer is switched
off when it is left unattended, e.g. during assembly and disassembly work,
voltage drop, insertion and/or assembly of accessories.
9. Do switch off the tool if it stops to operate due to whatever cause in order to
avoid a sudden start of operation when it is unattended.
10. Do always lead the cable away behind the tool.
11. Do not use the tool if a part of the housing and/or the switch, cable or plug is
damaged.
12. Power tools shall be inspected by an expert regularly.
13. Do not touch rotating parts.
14. Be careful with long hair. Do not wear loose clothing.
15. Do not manipulate the tool.
16. Do ensure that the handle bars are dry, clean and free from oil and grease.
17. When the tool is operated manually, make sure that you always hold the
tool with both hands and you stand in a firm position. Be aware of the
reaction moment of the tool.
Содержание BMR101
Страница 43: ...1 2 3 4 5 6 30 mA 7 8 9 10...
Страница 44: ...11 12 13 14 15 16 17 18 140 UT1401 180 UT1600 M14 14 SW22 UT 1401 SW 27 UT 1600...
Страница 46: ...EN 60745 EN 60745 2012 18 EU...
Страница 48: ...Makita Corporation Anjo Aichi Japan www makita com...