P 10/14
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -6. Swash Bearing Section (cont.)
DISASSEMBLING
9) Remove Helical gear 25 using 1R022, 1R023 and 1R281 as illustrated to left in Fig. 31. Swash bearing 10 and Clutch cam
can now be removed by hand (right in Fig. 31).
10) Remove retaining ring S-7 using No.1R291 (left in Fig. 27). Compression spring 7 and Spur gear 10 can now be removed
by hand. (right in Fig. 32).
Fig. 32
Fig. 31
Fig. 33
Fig. 34
Fig. 35
Swash
bearing 10
Clutch cam
Retaining
ring S-7
Compression
spring 7
Spur gear 10
Cam shaft
Helical gear 25
1R023
1R281
1R022
1R291
ASSEMBLING
1) Assemble Swash bearing section using 1R034 as illustrated in Fig. 33.
Note: 1. Be sure to put Flat washer 8 in place or Bearing retainer will be clamped between Ball bearing 608ZZ and
Helical gear 25.
2. Assemble the following parts after Cam shaft is installed on Inner housing;
Clutch cam, Spur gear 11, Compression spring 7, Retaining ring S-7
2) Assemble Piston joint and two Flat washers 12 to Piston cylinder as illustrated in Fig. 34.
Note: Do not forget to apply molybdenum disulfied grease (Fig. 1).
3) Insert Piston cylinder into Inner housing (Fig. 35).
1R034
Swash
bearing 10
Helical
gear 25
Cam shaft
Flat washer 8
Ball bearing
608ZZ
Bearing retainer
Ring 8
Flat washer 12
Flat washer 12
Piston joint
Piston cylinder
Inner housing
Correct
Wrong
