Makita AN930H, Инструкция по эксплуатации

Страница: 7 / 32

7
If the tool does not actuate properly, disconnect
the air hose, and then reassemble the trigger
according to 1-4 shown above.
NOTE:
To set back to continuous nailing, follow the procedures
for changing the trigger above.
OPERATION
CAUTION:
•
Make sure all safety systems are in working order
before operation.
•
When not operating the tool, always lock the trigger
by turning the change lever to the LOCK position.
•
Make sure that the trigger is locked when the
change lever is set to the LOCK position.
Checking continuous nailing mode
− The tool must not operate only by connecting the
air hose.
1
2
013440
− The tool must not operate only by pulling the trigger.
1
2
3
013503
− The tool must not operate only by placing the
contact element against the work piece without
pulling the trigger.
1
2
3
013489
− The tool should operate properly when pulling the
trigger first and then place the contact element
against the work piece.
Checking intermittent nailing mode
− The tool must not operate only by connecting the
air hose.
− The tool must not operate only by pulling the
trigger.
− The tool must not operate only by placing the
contact element against the work piece without
pulling the trigger.
NOTE:
•
The operating conditions shown above are the
same as the operating conditions mentioned in
"checking continuous nailing mode".
1
2
3
013441
− The tool must not operate when pulling the trigger
first and then placing the contact element against
the work piece.
Nailing method
1
2
013537
1. To drive a nail, you may pull the trigger first and
then place the contact element against the
workpiece, or
1
2
013538
1. Place first the
contact element
against
workpiece.
2. Pull the trigger
1. Pull the trigger
2. Place the
contact element
against
workpiece.
1. Trigger
2. Contact
element
3. Workpiece
1. Trigger
2. Contact
element
3. Workpiece
1. Trigger
2. Contact element
3. Workpiece
1. Trigger
2. Contact
element