4
ENGLISH
(Original instructions)
Explanation of general view
1
Shaft lock
2
Lock button
3
Switch trigger
4
Speed adjusting dial
5
Head cover
6
Screw
7
Screwdriver
8
Protrusion of loop handle
9
Matching hole in gear housing
10 Loop handle
11 Hex wrench
12 Bolt
13 Wool pad
14 Sleeve 18
15 Backing pad
16 Spindle
17 Wool bonnet
18 Lock nut
19 Rubber pad
20 Lock nut wrench
21 Dust cover
22 Limit mark
23 Brush holder cap
SPECIFICATIONS
• Due to our continuing program of research and
development, the specifications herein are subject to
change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE087-1
Intended use
The tool is intended for polishing.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
GEA010-1
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions.
Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
GEB038-3
POLISHER SAFETY WARNINGS
Safety Warnings Common for Polishing Operation:
1.
This power tool is intended to function as a
polisher. Read all safety warnings, instructions,
illustrations and specifications provided with
this power tool.
Failure to follow all instructions
listed below may result in electric shock, fire and/or
serious injury.
2.
Operations such as grinding, sanding, wire
brushing or cutting-off are not recommended to
be performed with this power tool.
Operations for
which the power tool was not designed may create a
hazard and cause personal injury.
3.
Do not use accessories which are not
specifically designed and recommended by the
tool manufacturer.
Just because the accessory can
be attached to your power tool, it does not assure
safe operation.
4.
The rated speed of the accessory must be at
least equal to the maximum speed marked on
the power tool.
Accessories running faster than
their rated speed can break and fly apart.
5.
The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool.
Incorrectly sized accessories
cannot be adequately guarded or controlled.
6.
Threaded mounting of accessories must match
the tool spindle thread. For accessories
mounted by flanges, the arbour hole of the
accessory must fit the locating diameter of the
flange.
Accessories that do not match the mounting
hardware of the power tool will run out of balance,
vibrate excessively and may cause loss of control.
7.
Do not use a damaged accessory. Before each
use inspect the accessory such as backing pad
for cracks, tear or excess wear. If power tool or
accessory is dropped, inspect for damage or
install an undamaged accessory. After
inspecting and installing an accessory, position
yourself and bystanders away from the plane of
the rotating accessory and run the power tool at
maximum no-load speed for one minute.
Damaged accessories will normally break apart
during this test time.
Model
9237CB
Max. capacities
Wool pad
180 mm
Wool bonnet
180 mm
Spindle thread
M14 or 5/8" (country specific)
Rated speed (n)/ No load speed (n
0
)
3,200 min
–1
Overall length
431 mm
Net weight
3.4 kg
Safety class
/II
