Makita 447 M, Руководство по эксплуатации

Страница: 14 / 164

10
MAKITA 447 M
english
7.2.3 Replacing filter element 1. Open the retaining clamps
and remove the upper sec-
tion of the cleaner from the
dirt tank. Lay the upper sec-
tion of the cleaner down with
the filter element facing up-
wards. Do not place the up-
per section of the cleaner
on the guard (1) and do not
damage the filter element.
2. Open the bar handle (2) and
remove it.
3. Remove the filter holder (3).
4. Carefully remove the filter el-
ement.
5. Clean the filter seal (4).
Check it for damage and re-
place it if necessary.
6. Check the antistatic clamp
(5) for damage and have it
replaced by Service if neces-
sary.
7. Check that the control flap
(6) for filter cleaning works
properly. The control flap
should move back and for-
wards easily.
8. Clean the level hose (7).
9. Fit a new filter element.
10. Fit the filter holder. Ensure
that it is in the correct posi-
tion.
11. Fit bar and close bar handle.
12. Dispose of the used filter ele-
ment in accordance with le-
gal regulations.
During the following work, en-
sure that dust is not unnecessarily
spread around. Wear a P2 breath-
ing mask.
auto
5
1
3
2
7
6
7.2.4 Emptying dirt tank 1. Remove the upper section of
cleaner from the dirt tank.
2. Using one hand, take hold of the
dirt tank underneath and tip out
the dirt.
3. Dispose of the dirt in accordance
with legal regulations.
4. Clean the rim of the tank before
fitting the upper section of clean-
er.
Before reinserting the suction hose:
5. Clean the inlet fitting and hose
collar.
Only after picking up harmless dust
without a filter bag.
4
Never use the vacuum cleaner
without a filter.