Makita 0088381836906, Инструкция по эксплуатации

Страница: 7 / 60

7 ENGLISH
Lighting up the front lamp
► Fig.4: 1. Lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 10 seconds after
releasing the switch trigger.
NOTE:
Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Reversing switch action
► Fig.5: 1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may damage the tool.
CAUTION:
When not operating the tool, always
set the reversing switch lever to the neutral position.
This tool has a reversing switch to change the direction of rota-
tion. Depress the reversing switch lever from the A side for clock-
wise rotation or from the B side for counterclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
LED indicator / Beeper
► Fig.6: 1. LED indicator
LED indicator / Beeper on the tool shows the following functions.
Function Status of the tool Status of the LED indicator/beeper Action to be taken
LED indicator Beeper
Auto-stop with fastening
completion
The preset fasten-
ing torque has been
achieved and the tool
has stopped.
Lights up in green for
approximately one
second.
– –
Alarm against insuffi -
cient fastening
The preset fastening
torque has not been
achieved, because
the switch trigger has
released before complet-
ing the fastening.
Lights up in red. A long beep Retighten the screw.
Alarm for low battery
capacity
The battery power
became low and it is
time to replace the
battery cartridge.
Flickers in red slowly. A series of long beeps Replace the battery with
fully charged one.
Auto-stop with low
remaining battery
capacity
The battery power is
almost used up and the
tool stopped.
Lights up in red. A long beep Replace the battery with
fully charged one.
Check of the LED indi-
cator, light and beeper
operation
When the battery
cartridge is installed,
the tool checks for its
LED indicator, light and
beeper.
Lights up first in green,
next red.
(And then the light
comes on.)
A series of very short
beeps
–
Anti-reset of controller The battery voltage
dropped abnormally for
some reason, and the
tool stopped.
Flickers in red and green
alternatively.
A series of short beeps Replace the battery with
fully charged one.
Overheat protection Tool's controller heated
up abnormally and the
tool stopped.
Flickers in red quickly. A series of short beeps Remove the battery car-
tridge immediately and
cool the tool down.
Detection of switch
trigger operation when
installing battery
When the battery car-
tridge is installed with
the switch trigger pulled,
the tool stops to avoid
unintentional start.
Flickers in red and green
alternatively.
A series of short beeps Release the switch
trigger.
Motor failure detection Motor failure has been
detected. At this time,
tool does not work.
Flickers in red and green
alternatively.
A series of short beeps Ask your local Makita
Service Center for repair.
Double-hitting detection When the operator
starts to re-fasten an
already-fastened screw,
the tool detect it and
stops.
Lights up in red. A long beep –